For those of you who want to make the most out of the SNMP network scanning - I would like to forward all of your attention to an open source command line tool for snmp queries you can use to learn a lot about your devices and then configure SysAid to extract and save that information.
This net-snmp tool will allow you to be able to send simple queries to your SNMP devices and receive the values.
You can also run a full SNMP walk command and get all the values from the device.
We developed a small SNMP tool based on the command line tool with a user interface you can simply [url=http://cdn3.sysaid.com/VisualSNMPSetup.exe]download and run the Windows version. ([url=http://cdn3.sysaid.com/VisualSNMP-linux-x64.tar.gz]Linux and Mac versions are also available)
Learn more about the tool Here
If you wish to go for the command line tool follow the instructions below:
Download the third link on the download page or click this direct link : net-snmp-5.4.2.1-1.win32.exe
Perform a default installation – next next….
Open a command line prompt in Windows: (cmd)
The following command lines are usefull:
Get value of a single OID:
snmpget -v1 -c public <device IP> OID
Example : snmpget -v1 -c public 192.168.1.1 1.3.6.1.2.1.43.5.1.1.1.1.0
Get all values of a sub tree:
snmpwalk -v 1 -c public <IP-ADDRESS> mib-2
snmpwalk -v 1 -c public <IP-ADDRESS> private
snmpwalk -v 1 -c public <IP-ADDRESS> mgmt
The outputs are long so you can add "> file1.txt" to the end of each command : snmpwalk -v 1 -c public <IP-ADDRESS> mgmt > mgmt.txt
If you find OID-s of interesting information for printers like page counter , toner level , or any other interesting information for network devices – please post them here !
Good Luck !
Oded
